Hey, thank you for listening to living water irrigation, Tulsa. Today we’re going to be talking about some of the different products that hunter irrigation has. We primarily use a hundred irrigation products here at living water irrigation in Tulsa. There are some of the best and most reliable products that are out there on the market. Hunter has made its reputation on the quality, reliability, and innovative features. Found that it’s rotary sprinkler line and continues to set the benchmark by which other manufacturers rotors are judged from spacings that can shoot 15 feet up to 160 feet. You’ll find a hundred irrigation sprinkler product that meets your needs onto the comparison chart from the half inch and three quarter inch inlet rotor is that hunter irrigation has to offer and then to the one inch and 1.5 inch inlet irrigation rotors that hunter has to offer.
The first one we’re going to be talking about is the p g. G. A. It has a radius that can go anywhere from 15 feet in spraying distance up to 37 feet and a maximum two Bray distance and the flow for the PG. Jay is 0.64 up to 5.3 gallons of flow per minute for the PGA. The inlet size for the PG Jay happens to be the one half inch NPT onto the SRM. The SRM model rotor has a radius that can spray it anywhere from 15 feet and all the way up to 30 feet. The flow rate for the SRM rotor is 0.42 and all the way up to 3.4 gallons per minute and it is also a half inch NPT. So as you can see, the PJ and the SRM can run through a good amount of water. That PGP Dash Adj is the third one we’re going to be talking about today and it is a little bit stronger than the last two. It has a radius of about 22 feet and can go up to 52 feet. It’s four rate is half 0.05 gallons per minute all the way up to just over 14 gallons per minute out of 14.1 the inlet size for this p g p Dash Abj. Uh, Hunter Irrigation Rotor irrigation in Tulsa has an inlet size of three quarter inch and p. T.
The next pop up had, we’re going to be talking about that as a hunter irrigation product. Hunter irrigation. Tulsa is the P G P ultra. It has a radius of 17 feet and you can spray all the way out to a whopping 47 feet. The flow rate for the PGP ultra begins at 0.036 and goes all the way up at the 14.8 gallons of water flow through the rotor per minute. The inlet size on this one is three quarter inch NPT. The next product is the eye 20 rotor. It has a radius of 17 feet and goes all the way up to 46 feet. The floor rate for this one is similar to the last one as it is 0.36 feet all the way up to 14.8 in gallons per minute just like the PGP ultra and then there’s also a three quarter inch NPT, so the eye 20 and the PGP ultra are very similar in the way they run.
The next one is the PGP ultra and the [inaudible] prb irrigation. Tulsa with a radius spray zone of 17 feet all the way up to 46 feet and a flow rate of 0.36 to 9.8 gallons per minute. This is a very good rotor. The inland size for the PGP ultra and I 20 prb is a three quarter inch NPT. Now the next road or that we’re going to be talking about is the [inaudible] and it has a radius of 40 feet to 71 feet. It is the largest rotary we have talked about thus far. It can spray, like I said, all the way up to 71 feet irrigation Tulsa as a flow rate of 3.8 gallons per minute and all the way up to 31.5 gallons per minute. It also has the highest flow rate that we have talked about thus far. The inlet size for the eye, 25 is the biggest one as well at one inches, so it’s inland size is one inch.
Now we go on up to the [inaudible], which has a back spray option as well. It has a radius that begins at 44 feet and it can go all the way out to a whopping 69 feet. The flow rate for the eye 40 begins at 7.6 and goes up to 29.5 gallons per minute. The I have 40 has an inland size of one inch NPT. The next 1:00 AM I going to be talking about is also the strongest one we’ve talked about thus far. It is the I 80 the IAT hunter irrigation. Tulsa rotor has a radius that sprays from 37 feet in distance all the way to just short of 100 feet in distance at 97 feet. The flow rate for the IAT Irrigation Tulsa and nozzle is 8.9 to 58.5 gallons per minute. The inlet size for this IAD comes in two different sizes and that is one inch and one inch 0.5 the last rotor that hunter has to talk about is the I 90 it has a whopping radius.
The biggest one we’ve talked about so far that begins at 73 feet and can shoot all the way out to 104 feet. The flow rate for the [inaudible] rotor is 29.5 gallons per minute and goes all the way up to a huge amount at 83.8 gallons per minute. The inlet size for the I 9,000 Irrigation Tulsa Rotor is one and a half inches in PT at living water irrigation here in Tulsa Irrigation Tulsa. We primarily use these hunter products. If we were to use our rotor, well often we do not need the distances of the IAD and the [inaudible]. Typically we use the P G J, which is the one with the radius that goes from 15 feet to 37 feet with the flow rate of 0.64 all the way to 5.3 gallons per minute. We also use the PGP a Dj and the PGP ultra. The PGP has a flow rate of 0.5 to 14.1 gallons per minute and it has a radius spray zone of 22 feet all the way out to 52 feet. The ultra, the PGP ultra irrigation Tulsa has a radius of 17 feet out to 47 feet with a flow rate of 0.36 to 14.8 gallons per minute with an inland size of three quarter inches. Here at living water, irrigation, Tulsa. We use these hundred products because we believe they are built on innovation and it provided a very quality product that our customers will be able to use for years and years to come.